All Products

72-5273RK Eagle Portable Monitor for CH4 % LEL/% Volume (IR) Auto-Ranging)/H2S (0-1.0 PPM) by RKI Instruments

The Eagle Portable Monitor can simultaneously detect up to 6 different gases. With over 400 gas monitoring configurations, the unit can detect a wide range of toxic gases. RKI Industries offers long life protection for workplace safety and hazardous jobsites. With a reputation for advanced engineering and state of the art technology, the RKI Industries' Eagle One to Six Gas Portable Monitor is an industry leader in accuracy and affordability.

Features

The Eagle One to Six Gas Portable Monitor is available with a wide variety of exclusive features. The unit is capable of PPM/LEL hydrocarbon detection and for environmental use, has a methane elimination switch. The dual hydrophobic filters (available on some models) ensure quality control. To preserve the integrity and safety of the device, the portable monitor also has an adjustment lockout switch to prevent tampering. For quick and easy testing, the monitor offers autocalibration and single gas calibration.

The Eagle is housed in an ergonomic RFI, EMI, chemical, and weather resistant polycarbonate and polyester enclosure. It can operate in the rain or in 2 inches of water without damage. It features an ergonomically designed top handle to ensure durability.

Accessories and Options

IR Sensors are available for CO2, % LEL CH4 or HC, and % volume CH4 or HC. Each unit also has datalogging capabilities for research, evaluation, and analysis of worksite atmospheres. The unit comes standard with several accessories including a shoulder strap, alkaline batteries, a hydrophobic probe, a 5 foot hose, and an internal hydrophobic filter with most models. Optional accessories can be purchased to fully customize the portable monitor to meet specific needs including a datalogging kit, remote alarms, dilution fitting, Ni-Cad batteries, battery chargers, continuous operation adapter, extra loud buzzer, extension probes, and large internal hydrophobic filter.

Specifications

The Eagle has a battery life of up to 30 hours of continuous operation with alkaline or Ni-cad capability and a sensor life of approximately 2 years. Its standard weight is approximately 5 pounds with dimensions of 10.5 L x 5.9 W x 7 H. The formidable long life pump (with a life of approximately 6,000 hours) reaches up to 125 feet in range with filters and has a low flow pump shut off and alarm. The unit has a response time of up to 30 seconds for most gases, and features a double alarm of audible alerts at 85 dB and visual alerts of dual high intensity LEDs and a flashing display screen.

The display screen is an easy to read 4 x 20 LCD readout. The backlit display sits at the top of the unit for full visibility, and displays the readings and statuses of 4 channels simultaneously.

The portable monitor is rated as intrinsically safe and has a standard 2 year warranty for materials and craftsmanship.

*Please note we can only ship RKI products to customers within the United States

*Please note we can only ship RKI products to customers within the United States

18109162-3121 Ventis Slide-on Pump, Alkaline battery pack, High Visibility Orange, ATEX/IECEx, English /French /Spanish /German /Chinese by Industrial Scientific

The Ventis® Slide-on Pump is ideally suited for operators who wear their gas monitors for personal protection but occasionally require a pump for confined space entries. Available in black or safety orange and powered by its own battery, the slide-on pump is compatible with the Ventis MX4 and Ventis Pro5 Multi-Gas Monitors.

32054 Advanced VX 6" Newtonian Telescope by Celestron

For those new to astronomy and astroimaging, the Advanced VX 6" Newtonian is an excellent entry-level setup that can grow with you. The Newtonian optical design is excellent for visual observing and offers you the largest aperture for the price. Combined with our Advanced VX mount, you'll have all the tools you need to learn the basics of imaging.

• 6" (150 mm) f/5 optical design gives excellent wide field views
• Parabolic primary mirror minimizes spherical aberration to produce a better image
• Integer gear ratios and permanently programmable Periodic Error Correction eliminates recurring track errors from the worm gear
• New motors offer improved tracking performance & provide more power to overcome load imbalances
• Updated industrial design offers more rigidity, less flexure and improved aesthetics
• New design allows viewing or imaging across the meridian without interference from the motors housings
• Improved latitude range, can be used between 7 - 77 degrees latitude
• Improved electronics contain increased memory for future expansion
• NexStar hand control offers multiple language programming (English, French, Italian, German, Spanish)

About the Mount

The new Advanced VX mount was specifically designed to provide optimum imaging performance for smaller telescopes. Now your smaller telescope can take advantage of All-Star Polar Alignment and autoguider support. You'll be able to track through long exposures using permanently programmable periodic error correction. Image across the meridian without doing a meridian flip, so you can seamlessly image the best part of night sky. Advanced VX features significantly larger base castings than our previous design, improving stability under heavier loads. Improved motors offer more torque and can handle slight load imbalances with ease.

*Please note we can only ship RKI products to customers within the United States

Part Number: BWS-Z-PCB1

3804-2000 EC 38 Fixed Transmitter with Carbon Monoxide (CO) Sensor, 1 ppm Resolution, 0 - 2,000 ppm Range by GfG

The EC 38 transmitter uses advanced technology for the detection of toxic gases and oxygen levels. It is available in the standard version with horn strobe or with a stack light. This monitor has a NEMA 4X enclosure that makes the EC 38 suitable for the harshest environments.

Simple and effective

Once you power up the units, they will accurately display values on the large LCD and transmit a linear 4-20 mA signal to a GfG controller. Autocal® automatic calibration and maintenance is done effortlessly through push buttons. Smart sensors allow the user to easily change ranges or gas types in the field without a need for additional programming.

• Advanced transmitter for oxygen and a wide selection of toxic gases
• 24 VDC
• Available with stack light or standard version with horn strobe
• AutoCal® automatic calibration
• Alarm relays standard (low, high and fault)
• Linear 4-20 mA output signal
• NEMA 4X housing

1888-711 TX400 Test Station for G888 / G999 with charging function by GfG

The TS400 and TX400 test stations quickly and automatically perform the required function tests on Microtector II G450 and G460 personal gas detectors. The TX400 can also be used to adjust sensors with test gas. Both test stations are available with an optional charging function for the portable gas detectors. Gas detection devices make a significant contribution to safety, if they are tested every working day.

Before each use of a portable gas detection device, its operational capability must be checked with a function test ("bump test"). We developed the TS400 and TX400 test stations to make this process as simple, quick and cost-effective as possible for our G450 and G460 portable devices, while still complying with the DGUV information 213-056 (T021) and 213-057 (T023). During the functional test, the test station can be operated using the display and buttons of the inserted gas detector.

Function test and adjustment

After a switched-on gas detection device is placed into either of the two test stations, the station will automatically start a function test. Within a maximum of 30 seconds, the alarms and response times are tested, the time and test interval are set, and the data is stored on a microSD card (optional). The device will then give you feedback about the test's success or, if applicable, any errors that occured. The TX400 can also be used for sensor adjustment. Before starting the adjustment, the zero point of the sensors must be set with fresh air. The sensor sensitivity is then readjusted using the appropriate test gas. Depending on the device and the number of sensors, this process will take a maximum of four minutes.

Power supply and charging function (optional)

The test stations are powered by an external 12-volt power supply unit or by a PC (connected via USB). If a gas detection device is placed inside the docking station while switched off, it will automatically start charging. Once it is fully charged, the test station will switch to trickle charge mode to conserve battery power. A 230 volt power supply or car charging adapter is required for the charging function.

Equipment and accessories

A gas extraction fitting (optional) should be used for test gas application with a gas cylinder. Both test stations are equipped with one input and one output each for supplying and withdrawing test gas. The data is documented on a microSD card. A mini-USB port can be used to connect the device to a PC.

Key features at a glance:

• Meets the requirements of DGUV information 213-056 (T021) and 213-057 (T023) as well as DIN EN 60079-29-2
• Suitable for the portable gas detection devices G450 and G460
• Function test, adjustment (TX400 only) and charging function (optional)
• Data storage on microSD card, data transfer to PC
• Optional: carrying case, power supplies (12 / 24 / 230 V), microSD card, data point software, gas sampling fitting
• Mobile use (no PC - 12/24 V power supply)

72-1005-10-CSA OX-600 Indoor Stand Alone Oxygen Monitor, 0-25%, 24 VDC Operation with 10 Meter Sensor Cable, CSA Version by RKI Instruments

RKI's Model OX-600 is an indoor, standalone monitor that detects Oxygen (O2) with a range of 0-25.0 % volume with 0.1% increments. It's sleek, low-profile design is equipped with a unique tri-color display, which changes color as oxygen levels reach each alarm level. The OX-600 has 2 preset alarms, and comes ready to operate with a simple wall mount bracket and 10 foot power cord. It is capable of operating with three different power options; 115 VAC, 24 VDC or alkaline batteries. If Oxygen is present, the user is notified by an audible alarm tone and the multicolored LED digital display.

The OX-600 uses a fast responding low-cost plug-in style galvanic cell sensor. This long life sensor is fieldreplaceable with no special tools required. The sensor can also be remotely mounted with an optional remote sensor cable.

Features

• Operates with or without a controller
• Tri-color visual alarm display: Green=Normal, Yellow=Alarm 1, Red=Alarm 2
• Large easy to read digital display
• Three power options: 115 VAC, 24 VDC, or 2 AA alkaline
• Operates up to 1 year on one set of AA alkaline batteries
• Pressure compensation eliminates false alarms caused by pressure change
• Remote mount sensor cable available

Applications

• Laboratories
• Cryogenic environments
• Clean rooms
• Industrial gas facilities
• Gas storage rooms
• Indoor monitoring
• Iron and steel industry
• Warehouses
• Tunnels and garages
• Vehicle service areas

*Please note we can only ship RKI products to customers within the United States

TX2-21011 Tango TX2 Dual Gas Monitor, H2S, CO by Industrial Scientific

• Protect workers, reduce false alarms, and spend less time managing your gas detector fleet with the Tango TX2.
• The Tango TX2 is the most accurate two-gas monitor featuring individual sensors that increase alarm accuracy.
• A two-year runtime and replaceable battery simplify gas detection management by eliminating the need for charging infrastructure.

72-5243RK-03 Eagle Portable Monitor for LEL/CO2 (5% Volume) by RKI Instruments

The Eagle Portable Monitor can simultaneously detect up to 6 different gases. With over 400 gas monitoring configurations, the unit can detect a wide range of toxic gases. RKI Industries offers long life protection for workplace safety and hazardous jobsites. With a reputation for advanced engineering and state of the art technology, the RKI Industries' Eagle One to Six Gas Portable Monitor is an industry leader in accuracy and affordability.

Features

The Eagle One to Six Gas Portable Monitor is available with a wide variety of exclusive features. The unit is capable of PPM/LEL hydrocarbon detection and for environmental use, has a methane elimination switch. The dual hydrophobic filters (available on some models) ensure quality control. To preserve the integrity and safety of the device, the portable monitor also has an adjustment lockout switch to prevent tampering. For quick and easy testing, the monitor offers autocalibration and single gas calibration.

The Eagle is housed in an ergonomic RFI, EMI, chemical, and weather resistant polycarbonate and polyester enclosure. It can operate in the rain or in 2 inches of water without damage. It features an ergonomically designed top handle to ensure durability.

Accessories and Options

IR Sensors are available for CO2, % LEL CH4 or HC, and % volume CH4 or HC. Each unit also has datalogging capabilities for research, evaluation, and analysis of worksite atmospheres. The unit comes standard with several accessories including a shoulder strap, alkaline batteries, a hydrophobic probe, a 5 foot hose, and an internal hydrophobic filter with most models. Optional accessories can be purchased to fully customize the portable monitor to meet specific needs including a datalogging kit, remote alarms, dilution fitting, Ni-Cad batteries, battery chargers, continuous operation adapter, extra loud buzzer, extension probes, and large internal hydrophobic filter.

Specifications

The Eagle has a battery life of up to 30 hours of continuous operation with alkaline or Ni-cad capability and a sensor life of approximately 2 years. Its standard weight is approximately 5 pounds with dimensions of 10.5 L x 5.9 W x 7 H. The formidable long life pump (with a life of approximately 6,000 hours) reaches up to 125 feet in range with filters and has a low flow pump shut off and alarm. The unit has a response time of up to 30 seconds for most gases, and features a double alarm of audible alerts at 85 dB and visual alerts of dual high intensity LEDs and a flashing display screen.

The display screen is an easy to read 4 x 20 LCD readout. The backlit display sits at the top of the unit for full visibility, and displays the readings and statuses of 4 channels simultaneously.

The portable monitor is rated as intrinsically safe and has a standard 2 year warranty for materials and craftsmanship.

*Please note we can only ship RKI products to customers within the United States

*Please note we can only ship RKI products to customers within the United States

600-0050-002 Four-Gas Calibration Mix with SO2, 58L Aluminum Cylinder (50% LEL CH4, 20.9% O2, 5 PPM SO2, 50 PPM CO, Balance N2) by RAE Systems

Standard single-gas and multi-gas mixtures for monitor calibration

• Sizes range from 11 liters to 103 liters
• Convenient multi-gas mixtures
• Choose between demand-flow and constant-flow regulators

1-Phase/2-Speed Motor, 1/2 Hp, 115V, 1-Phase, Oscillating, 1075/750 rpm