$150 - $200

This is the equivalent of the CG3-H-25-58 from BW

Part Number: 58L-99-25

Part Number: 34L-62A-1.15

Part Number: 221L-355

37803-88 Traceable® High-Accuracy RTD Refrigerator/Freezer Digital Thermometer with Calibration by Digi-Sense

Easily monitor temperature in liquids, baths, air/gas, incubators, refrigerators, or freezers. Keep track of temperature conditions overnight or for any time period-minimum and maximum temperatures are stored until the memory is cleared. The 4-wire platinum probe insures linear response and high accuracy across the entire range.

The built-in alarm provides an alert when temperature rises above or falls below a user defined set point, and is programmable in 1° increments. A visual and audible signal continues even if the temperature returns to non-alarm range until reset by the user.

Probe is attached to a 10-ft (3 m) micro-cable that permits a doors to close on it; probe and cable are both submersible. Mount meter with included Velcro® strips, wall-mount slots, or use flip-open stand on benchtop.

Traceable® products are calibrated to NIST-traceable standards and ready to use as soon as you receive it. Each product goes through an intense vetting process before it can carry the Traceable name, and it includes NIST-traceable certification. This means that a 17025-accredited calibration test lab has confirmed that the product meets or exceeds all stated specifications, saving you both time and money by not having to calibrate separately.

NIST-traceable calibration also helps you meet quality standards and regulatory compliance for ISO, FDA, cGMP, VFC, CAP, CLIA and Joint Commission requirements.

Model 37803-88 is supplied with a special bottle probe specifically designed for refrigerator/freezer applications. The temperature sensor is enclosed in a bottle, which protects it from rapid temperature changes when refrigerator door is opened.

• Get accurate, reliable measurements with included NIST-traceable calibration
• Temperature-buffered platinum RTD probe
• RTD probe insures linear response and high accuracy across the entire range
• Triple-display-shows high, low, and current temperature simultaneously

Includes

NIST-traceable calibration certificate with data, plastic stand, double back tape and Velcro® for attaching holder to any surface, stainless-steel probe(s), and two AA batteries

Part Number: J197885VN

Part Number: 221L-332

Old Part Number: 1049100
New Part Number: J1049100PA

This is the equivalent of the CG2-S-25 from BW

Part Number: 58L-175-25

Part Number: 103L-34-1000

Part Number: 103L-374

378JF Digital Thermometer Controller with Analog Voltage Output, Range 0 to 1000 °F by Jenco

Panel mount digital thermometer controller with analog voltage output of 1 mV per count, ± 3%, bright red LED display, 1/8 DIN plastic housing, hysteresis is ± 3°C or ± 5°F. Proportional Band-Width control from 5%, 378KF, 10% 378 KC/JF and 20% of span for 378 JC. Features manual adjust reset. Cycle time is 20 seconds ± 3 seconds. 115/230V AC operation.