$100 - $150

765EF Thermocouple Panel Thermometer, Type E, Range -157 °F to 1832 °F by Jenco

Panel mount digital thermometer with analog voltage output of 1 mV per digit, with analog output accuracy of ± 0.2%, features a bright red LED display and 1/8 DIN plastic housing. °C/°F selectable via plastic jumper behind front bezel. Available in types. J, K, T, E, and 3-wire Pt-100 RTD. Ambient range 0 to 60°C. 115/230V AC operation.

• High accuracy
• 50/60 hz rejection design
• Compact 1/8 DIN plastic case
• °C/°F selectable w/ re-calibration
• Models available for k,j,t,e pt-100
• Upscale break detection
• Cold junction consumption design
• 1mv/digit analog output
• Easy to install
• 0.56 high efficiency ide display

H-10-109-20 Nitrogen Oxides Colorimetric Gas Detection Tube, 1 - 50 ppmv (5 Colorimetric Tubes and 5 Pre-Tubes) by RAE Systems

RAE Systems colorimetric gas detection tubes enable quick, on-the-spot measurement of a wide range of toxic and combustible gases and vapors. RAE Systems tubes are easy to read, and provide a sharp, clear color change directly corresponding to the concentration of gas present. RAE Systems tubes are compatible with the RAE Systems piston hand pump, a reliable way to draw samples of an exact volume required for the most accurate measurements.

Key Features

• Wide assortment of tubes available to detect over 300 gases and vapors
• Easyto use, even in multiple layers of gloves
• Easy-to-read with sharp,clearcolorchange
• No calibration or other maintenance required

Applications

• Oil and gas
• Chemicals and petrochemicals
• Agriculture and pestcontro
• Food and beverage production
• Environmental protection
• Fire service
• HazMat response
• Nationalsecurity

600-0002-000 Isobutylene, 100 PPM (Balance Air), 34L Steel Cylinder by RAE Systems

Standard single-gas and multi-gas mixtures for monitor calibration

• Sizes range from 11 liters to 103 liters
• Convenient multi-gas mixtures
• Choose between demand-flow and constant-flow regulators

2429600 Silca HR Reagent Set (Hach) by AquaPhoenix

For High Range Silica determination by the Silicomolybdate method.
Hach Method 8185. Range: 1 - 100 mg/L SiO2. Sample Size: 10 mL.
Set contains Acid Reagent Powder Pillows, Citric Acid Powder Pillows and Molybdate Reagent Powder Pillows for 100 tests.

*Please note we can only ship RKI products to customers within the United States

H-10-119-20 Trichloroethylene Colorimetric Gas Detection Tube, 5 - 100 ppmv (5 Colorimetric Tubes and 5 Pre-Tubes) by RAE Systems

RAE Systems colorimetric gas detection tubes enable quick, on-the-spot measurement of a wide range of toxic and combustible gases and vapors. RAE Systems tubes are easy to read, and provide a sharp, clear color change directly corresponding to the concentration of gas present. RAE Systems tubes are compatible with the RAE Systems piston hand pump, a reliable way to draw samples of an exact volume required for the most accurate measurements.

Key Features

• Wide assortment of tubes available to detect over 300 gases and vapors
• Easyto use, even in multiple layers of gloves
• Easy-to-read with sharp,clearcolorchange
• No calibration or other maintenance required

Applications

• Oil and gas
• Chemicals and petrochemicals
• Agriculture and pestcontro
• Food and beverage production
• Environmental protection
• Fire service
• HazMat response
• Nationalsecurity

Old Part Number: 101680N
New Part Number: J101680PN

BMCSPT01 Sample Pot incl. Fittings and Calibration Solutions by Bluelab

Get accurate probe readings and protect your probes from damage with a sample pot. Our sample pots come with fittings for easy installation.

Suitable for use with Bluelab Intellidose Controller and Bluelab Guardian Monitor Wi-Fi (excluding Inline).

This sample pot is key to accurate probe readings and protecting your probes from damage. The sample pot is a very important part of any monitoring/dosing system. You simply mount this pot on the wall near the controller, and place the pH and/or EC probe into it. A pump in the reservoir will keep water flowing 24/7, so the probes are always getting the most accurate readings. Keeping the probes in the sample pot makes sure they cannot be broken or accidentally removed from the reservoir and they are easy to calibrate.

270 Clamp-On Tester with Digital Multimetervisit by Test Products International

Perfect for tight, narrow, spaces. The new TPI 270 with slim jaw and body is ideal for cramped work areas and crowded electrical panels.

The slim design 270 is a hand-held, autoranging clamp-on DMM. Extra large numerals, min/max, capacitance, DC microamps and duty cycle are just a few of the features of the 270. An affordable choice, the 270 offers measurements in all basic electrical functions with additional advanced features like non-contact voltage.

Features:

• Measure motor in-rush current and run current
• Measure temperature differential with relative mode
• Non-contact voltage feature can be used to immediately see if power is being supplied to the 24VAC control circuit of thermostats
• Frequency, Min/Max/Record, Data Hold and Peak Hold
• Up to 40,000 Microfarads to test run and start capacitors
• 4,000 count display with 41 segment analog bargraph
• Auto & Manual Ranging
• Low Battery Indicator
• Over Range Indication ("OL")
• Hi Voltage Indicator (>30V AC/DC)
• Auto Power Off after 30 minutes
• Separate Battery/Fuse Compartment
• Low Ohm Range (400V)
• Amps AC Resolution: 0.01A
• VDC/VAC Resolution: 0.1mV
• DC μA measurement (0.01 μA resolution)
• Temperature measurement with 0.1° resolution

Applications:

• Measure flame safety control current
• Test run and start capacitors and motors
• Measure motor run current and capture peak motor start up amperage
• Measure heat anticipator current
• Determine thermocouple voltage
• Test line and control voltages
• Measure heating element resistance
• Measure air temperature in ducts
• Test for the presence of voltage in circuits without contacting the circuit
• Measure temperature differential using relative mode

The 270 comes complete with the following accessories:

• Carrying Pouch
• Test Lead Set
• Temperature Probe
• Instruction Manual
• Battery & Fuse

Part Number: CG2M35103

AI4205 T500-S1 AMCO Turbidity Standard Calibration Solution Kit (20/100/400/800NTU) for TN500 by Apera

The standards have a guaranteed one-year shelf life even if you've opened the bottle and happened not to have recapped it tightly.

The convenient submicron polymer suspensions are non-toxic primary calibration standards approved by the US EPA for drinking water analysis for turbidity.

• Standard Calibration Solution Set for Apera Instruments White Light Portable Turbidity Meters (TN500 and TN420)
• AMCO Clear® turbidity standard solutions (20.0 NTU, 100 NTU, 400 NTU, 800 NTU).
• AMCO Clear® is an EPA approved primary standard for calibration of turbidity sensors that is safe, non-toxic and disposable. It is easy-to-use with no dilution or resuspension, and it is available in a wide range of values.

Part Number: F111450PA

*Please note we can only ship RKI products to customers within the United States

MiSC-LEDEU Slim Light Table for MiScope for EU by Zarbeco

The portable 4 x 5 inch illuminated light table works with a rechargeable lithium battery or the USB/AC adapter.

The light table is suitable for viewing transparent objects that need bottom lighting to see.

Use with any MiScope or MiScope megapixel 2 that has a switch to turn off the LEDs (MISC-SW; MISC-IR; MISC-UV; MISC-UVIR; MISC-MP2; MISC-M2P-IR; MISC-MP2-UV; MISC-MP2-WUVIR).

View slides, detect watermarks, or view through any transparent object.

Features

• portable, lightweight
• powered by rechargeable lithium battery or USB/AC adapter

Applications

• Forensics (ie watermarks)
• Laboratory to view slides
• Quality inspection of transparent samples

PROBPHLEAP Leap pH Probe by Bluelab

Reliably measure the pH level across a wide range of media. Suitable for use with all Bluelab® products that use a BNC connection.

The Bluelab® Leap™ pH Probe can be used by everybody from the home enthusiast through to more robust commercial applications. Team with Bluelab® Solutions.

Features

• Test more with a faster sensor response and direct measurements from substrates
• Multimedia friendly, for measurements across a range of environments
• Toughened spear tip for direct root-zone measurements
• Dibber / auger included
• 2 meter / 6.6 foot standard cable

Part Number: CGT1031

To enable manual sampling. Includes aspirator bulb, flow plate and 2m of standard sampling hose.