$25 - $50

10-137-30 Butane Colorimetric Gas Detection Tube, 25 - 1,400 ppmv (10 Tubes / Box) by RAE Systems

RAE Systems colorimetric gas detection tubes enable quick, on-the-spot measurement of a wide range of toxic and combustible gases and vapors. RAE Systems tubes are easy to read, and provide a sharp, clear color change directly corresponding to the concentration of gas present. RAE Systems tubes are compatible with the RAE Systems piston hand pump, a reliable way to draw samples of an exact volume required for the most accurate measurements.

Key Features

• Wide assortment of tubes available to detect over 300 gases and vapors
• Easyto use, even in multiple layers of gloves
• Easy-to-read with sharp,clearcolorchange
• No calibration or other maintenance required

Applications

• Oil and gas
• Chemicals and petrochemicals
• Agriculture and pestcontro
• Food and beverage production
• Environmental protection
• Fire service
• HazMat response
• Nationalsecurity

Package Includes: 2 Clips, 2 leads and ground lead

Part Number: 17L-80-500

TDSK1800 Conductivity Solution, 901.6ppm/1800uS, 1Qt by Sensorex

TDS/Conductivity instruments and sensors must be calibrated together. For a single-point calibration, select the one solution that approximates the expected conductivity or ppm level of total salts. Mixed Salt standards are the most frequently used in the field to sample naturally occurring water sources, boiler feed water, or cooling tower water. Typical river water, well water, or lake water sample will contain a mixture of several different salts. Sensorex Mixed Salt standards simulate a "Natural" mixture of common salt compounds found in these sources. Sodium sulfate, sodium bicarbonate, and sodium chloride salts are blended to provide a representative value. There are certain applications where Single Salt Solutions are preferred. NaCl Solution is routinely used to calibrate instruments measuring Sea Water or brackish water samples. Reagent grade salt and high resistivity DI water is compounded for accurate results. KCI Single Salt Solution may be used with conductivity meters that read directly in Siemens or Ohms. KCI (potassium chloride) is established as an international calibration standard for conductivity measurement. Choose the conductivity calibration solution that is right for your application. CA Residents: Prop 65 WARNING(S)

*Please note we can only ship RKI products to customers within the United States

94222 EclipSmart Solar Filter for 127mm/130mm Newtonian by Celestron

Get ready for the 2017 total solar eclipse with EclipSmart Solar Safe Products.

Enhance your viewing experience with Celestron's EclipSmart Solar Filter for the 127 mm & 130 mm Telescopes. With two Velcro straps and four self-adhesive Velcro pads for safely securing your solar filter in place, you can be assured that the solar filter will not fall off and will provide Solar Safe, ISO compliant viewing.

• Instantly transform your normal PowerSeeker 127, Astro Fi 130, NexStar SLT 130, Omni XLT 130AZ, and SkyProdigy 130 Newtonian telescope into a yellow-light solar telescope
• This filter is not designed for use on the AstroMaster 130 telescopes
• Solar film produced in the USA by American Paper Optics, one of the suppliers recommended by NASA for safe solar viewing
• Designed from the telescope s lens cap for a snug fit, each filter includes two safety Velcro straps and four self-adhesive Velcro pads for safely securing your solar filter in place

Solar Safe Technology

EclipSmart solar products feature Solar Safe filter technology providing the ultimate protection from harmful solar radiation, including both IR and UV light, and filters 99.999% of intense visible light. Celestron Solar Safe filter technology is GUARANTEED SAFE for direct solar observation and has been independently tested by SAI Global Assurance Services.

Solar Safe products conform to and meet the transmission requirements of ISO 12312-2, Filters for Direct Observation of the Sun, EN 1836:2005 + A1:2007 (E) for an E15 Filter for the Direct Observation of the Sun and, AS/NZS 1338.1:2012, Filters for Eye Protectors.

Length(MM) & Diameter : 213 X Ø15.00
Temperature: -100°C ~ +400°C OR -148°F ~ +752°F

94055 Dew Heater Ring - 5" by Celestron

The Celestron Dew Heater Ring is the ideal dew prevention solution for your Celestron telescope. This must-have accessory will improve your observing or imaging nights year-round. The Dew Heater Ring permanently mounts to your 5" Celestron Schmidt-Cassegrain optical tube, replacing your retaining ring, so you'll never be caught without it. The installation process is quick and easy (follow the manual for instructions).

How it works

The Dew Heater Ring replaces the plastic retaining ring on your Schmidt corrector lens for efficient heating across the lens. The ring is constructed of lightweight, durable aluminum. Its rigid frame supports the cable circuity and the telescope's Schmidt corrector lens. Unlike other heating bands or strips that inefficiently heat the lens cell to warm the glass, the Celestron Dew Heater Ring heats the corrector glass directly, providing the most efficient transfer of heat to prevent dew formation.

Simply plug the ring into an external 12V DC power source for consistent, continuous heat that will prevent dew from forming even under heavy dew conditions. The Dew Heater Ring features two storage clips to keep the power and thermistor jacks secure when not in use while accommodating the telescope's dust cover.

The Dew Heater Ring also comes with a cable management clip that connects to the telescope's front cell. Corral the power and thermistor jack to prevent them from dangling and reduce unwanted pulls on the cable connection to the rings.

The Dew Heater Ring comes complete with:

• Dew Heater Ring
• Cable management clip
• Power jack extension cable
• Paper installation shield

Enhance your setup

To achieve the highest level of dew prevention while maximizing power efficiency, we strongly recommend pairing the Dew Heater Ring with a Smart DewHeater Controller (sold separately). The controller uses the ring's built-in thermistor and its internal environmental sensor to provide just the right amount of heat to the corrector to prevent dew based upon the ambient temperature, ambient humidity, and temperature of the Schmidt corrector, which can dramatically reduce the ring's power draw, greatly increasing battery life. The ring also includes an extension cable for connecting the ring directly to one of the controllers' heater output ports, or to a third-party controller's heater output port. (Note: the ring's integrated thermistor is only compatible with the Celestron Smart DewHeater Controllers).

We also recommend adding a dew shield to your setup. While not mandatory, a shield will cut down on the amount of power the Dew Heater Ring needs to keep the optics clear.

• Heater ring provides the most efficient heating directly to the corrector lens to prevent the formation of dew
• Permanently mounts to your existing telescope tube for a seamless look–plus, you'll never forget to bring it with you
• Integrated thermistor continuously monitors the temperature of the corrector lens when used with the Celestron Smart DewHeater Controllers.
• Rigid, lightweight, and durable aluminum construction
• Included storage clip and cable management clip keep your cables organized

94253 EclipSmart Solar Filter for 5" Schmidt-Cassegrain Telescopes by Celestron

Turn your Celestron 5" Schmidt-Cassegrain telescope into a solar scope! The EclipSmart Eclipse Solar Filter is a must-have accessory perfect for viewing the Sun and eclipses like the upcoming 2023 Annular Solar Eclipse and 2024 Total Solar Eclipse. Affordable, easy to use, and best of all, all Celestron EclipSmart products conform to the ISO 12312-2:2015(E) international safety standard. This solar filter is custom designed for Celestron 5" Schmidt-Cassegrain telescopes. Two hook and loop straps securely hold the filter in place for a safe, snug fit.

Compatible Telescopes:

• NexStar 5SE
• Popular Science by Celestron StarSense Explorer 5"
• C5 Spotting Scope
• StarSense Explorer 5" Schmidt-Cassegrain – International Exclusive
• Astro Fi 5" Schmidt-Cassegrain – International Exclusive

Solar Safe Technology

EclipSmart solar products feature Solar Safe filter technology—the ultimate protection from harmful solar radiation, including IR and UV light, plus 99.999% of visible light. Celestron Solar Safe filter technology is SAFE for direct observation of the Sun and has been independently tested to conform to and meet the transmission requirements of ISO 12312-2:2015(E), Filters for Direct Observation of the Sun, EN 1836:2005 + A1:2007 (E) for an E15 Filter for the Direct Observation of the Sun and AS/NZS 1338.1:2012, Filters for Eye Protectors.

Important safety note: inspect your filter before every use. Do not use and discard if damaged, torn, punctured, or separated from the frame in any way.

• SOLAR SAFE TELESCOPE FILTER: Filter conforms to the ISO 12312-2:2015(E) international safety standard for filters directly viewing the Sun. The ideal tool for viewing eclipses, sunspots, or the Sun any day!
• WORKS WITH YOUR EXISTING TELESCOPE: Compatible with Celestron 5" Schmidt-Cassegrain telescopes.
• SAFE, SNUG FIT: Two hook and loop straps keep your filter securely attached to your telescope's objective.
• SOLAR FILM MADE IN THE USA: Our Solar Safe film is produced in the USA by American Paper Optics, one of the suppliers recommended by NASA for safe solar viewing.
• GREAT VIEWS AND IMAGES: This filter features an orange tint, producing a natural look perfect for visual observing and capturing images through your telescope.