$10 - $15

98768-37 8708 Reflective Tape for Noncontact Tachometers by Digi-Sense

Choose from a wide range of accessories for your Digi-Sense tachometer including replacement wheels, tips, and tape.

CA1119-B Calcium Hardness Buffer, 60mL by AquaPhoenix

Specifications

• Packaging Type: Poly
• Size: 60 mL

BS1077-B Fluoride Inhibitor by AquaPhoenix

Corrosive Liquid, Toxic/UN2922, 60mL

MO1460-B Molybdate Reagent, 60mL by AquaPhoenix

• for Phosphate (PO4)
• Corrosive Liquid NOS/UN1760

Specifications

• Packaging Type: Poly
• Size: 60 mL

ST2776-B Sodium Thiosulfate High Range, 60mL by AquaPhoenix

1 drop = 50ppm ClO2/ 10mL

MO1546-B Molybdenum Titrating Solution, 60mL by AquaPhoenix

Specifications

• Packaging Type: Poly
• Size: 60 mL

18527-90 Compression Fitting; Probe Diameter 1/8"; 316 Stainless Steel; 1/8" NPT (M) by Digi-Sense

Use fittings for straight-shaft probes and metal tubing only. Tighten compression nut to secure and completely seal probe. Replacement ferrules let you reuse a compression fitting when replacing a worn-out probe. Simply disassemble fitting, discard probe and old ferrule, install replacement ferrule over probe sheath, and retighten fitting. Connectors come in both 316 Stainless Steel and Brass.

• Available in both 316 Stainless Steel and Brass

TDS1500/P Conductivity Solution 1500 ppm, Pt Bottle by Sensorex

TDS/Conductivity instruments and sensors must be calibrated together. For a single-point calibration, select the one solution that approximates the expected conductivity or ppm level of total salts. Mixed Salt standards are the most frequently used in the field to sample naturally occurring water sources, boiler feed water, or cooling tower water. Typical river water, well water, or lake water sample will contain a mixture of several different salts. Sensorex Mixed Salt standards simulate a "Natural" mixture of common salt compounds found in these sources. Sodium sulfate, sodium bicarbonate, and sodium chloride salts are blended to provide a representative value. There are certain applications where Single Salt Solutions are preferred. NaCl Solution is routinely used to calibrate instruments measuring Sea Water or brackish water samples. Reagent grade salt and high resistivity DI water is compounded for accurate results. KCI Single Salt Solution may be used with conductivity meters that read directly in Siemens or Ohms. KCI (potassium chloride) is established as an international calibration standard for conductivity measurement. Choose the conductivity calibration solution that is right for your application. CA Residents: Prop 65 WARNING(S)